Table of Contents
Advertisement
(9) Serial Port COM1, COM2 : COM1, COM2
COM1, COM2 are the 9-pin D-Subminiature mail connector. The On-board serial port can be
disabled through BIOS SETUP. Please refer to Chapter 3 "INTEGRATED PERIPHERALS
SETUP" section for more detail information.
(10) Floppy drive Connector (34-pin block): FDD
This connector supports the provided floppy drive ribbon cable. After connecting the single
plug end to motherboard, connect the two plugs at other end to the floppy drives.
(11) Primary IDE Connector (40-pin block): IDE1
This connector supports the provided IDE hard disk ribbon cable. After connecting the
single plug end to motherboard, connect the two plugs at other end to your hard disk(s). If
you install two hard disks, you must configure the second drive to Slave mode by setting its
jumpers accordingly. Please refer to the documentation of your hard disk for the jumper
settings.
PS/2
LAN
Mouse
USB
COM1
PS/2
Keyboard
Pin 1
PRINT
GAME/MIDI PORT
COM2
Floppy Drive Connector
14
MIC
LINE-IN
LINE-OUT
Advertisement
Table of Contents
Need help?
Do you have a question about the PT800DB - REV 1.0 and is the answer not in the manual?
Questions and answers