Overclock Running; Install Memory - JETWAY 601TCFR3A User Manual

When you put the CPU into the ZIF socket. No forces require to insert of the CPU,
then press the level to locate position slightly without any extra force.
2-3-4 Over clock Running
WARNING! This section is for experienced motherboard installer only. Over
clocking can result in system instability or even shortening life of the
processor.
After setting the Jumper JMP1 you can choose over clock running by BIOS CMOS
SETUP UTILITY. When you entered CMOS SETUP UTILITY, choose "Miscellaneous
Control" you will see the screen as below then.
You can choose the situation you want to try.
CMOS Setup Utility – Copyright(C) 1984-2001 Award Software
CyrixIII Clock Ratio
Auto Detect DIMM/PCI Clock
Spread Spectrum
** Current Host Clock is 66MHz **
Host Clock at Next Boot is [66MHz/33MHz]
** Current DRAM Clock is 66Mhz **
DRAM Clock at Next Boot is [66]MHz
¡ ü ¡ ý ¡ ú ¡ û :Move Enter:Select
F5:Previous Values
In "Host Clock at Next Boot is" item you can step by step change CPU Host Clock to
approach over clocking.

2-4 Install Memory

This motherboard provides
(DIMM) sites for memory expansion available from minimum memory size over
32MB to maximum memory size of 1GB SDRAM.
Colden Arrow
Pentium  III
Miscellaneous Control
Default
Enabled
Disabled
+/-/PU/PD:Value
F6:Optimized Defaults
two 168-pin DUAL INLINE MEMORY MODULES
10
Socket 370
CPU ZIF Socket 370
Menu Level >
F10:Save ESC:Exit
F7:Standard Defaults
Item Help
F1:General Help