Expansion Card - JETWAY 601TCFR3A User Manual

Valid Memory Configurations
DIMM1 DIMM2
DS/SS
DS/SS
DS : Double Sided DIMM
NOTE! Make sure the total installed memory does not exceeds 1GB, otherwise the
system may hang during startup.
Generally, installing SDRAM modules to your motherboard is very easy, you can refer
to figure 2-4 to see what a 168-Pin PC100 & PC133 SDRAM module looks like.
DIMM1 (BANK0+ BANK1)
DIMM2 (BANK2+ BANK3)
NOTE! When you install DIMM module fully into the DIMM socket the eject tab should be
locked into the DIMM module very firmly and fit into its indention on both sides.
WARNING! If the SDRAM CLOCK is set at 133MHz, you must use only PC133-
compliant DIMMs. When this motherboard operate at 133Mhz, most
system will not even boot if non-compliant SDRAM modules are used
because of the strict timing issues, if your DIMM are not PC133-
compliant, set the SDRAM clock to 100MHz to ensure system's
stability.
2-5 Expansion Cards
WARNING! Turn off your power when adding or removing expansion cards or
other system components. Failure to do so may cause severe damage
to both your motherboard and expansion cards.
System Accept or Not
DS/SS
DS/SS
SS : Single Sided DIMM
Accept
Accept
Accept
Figure 2-4
11
Total Memory
Min. ∼ Max.
32MB∼512MB
32MB∼512MB
32MB∼1GB