Headers - JETWAY 601TCFR3A User Manual

setting its jumpers accordingly. Please refer to the documentation of your hard disk for
the jumper settings.
(10) Secondary IDE Connector (40-pin block): IDE2
This connector connects to the next set of Master and Slave hard disks. Follow the
same procedure described for the primary IDE connector. You may also configure two
hard disks to be both Masters using one ribbon cable on the primary IDE connector and
another ribbon cable on the secondary IDE connector.
•
Two hard disks can be connected to each connector. The first HDD is referred to as the
"Master" and the second HDD is referred to as the "Slave".
•
For performance issues, we strongly suggest you don't install a CD-ROM or DVD-ROM
drive on the same IDE channel as a hard disk. Otherwise, the system performance on this
channel may drop.

2-6-2 Headers

(1) COM2 Headers (9-pin header) : COM2
This board has another serial port COM2, it come with cable providing serial
port COM2.
Primary IDE Connector
Pin 1
Pin 1
Secondary IDE Connector
C O M2
Pin 1
Note: Orient the red marking on the
COM2 ribbon cable to pin 1
15