Advertisement
Quick Links
Technical Support and E-Warranty Certificate www.vevor.com/support
WHEEL ALIGNMENT SYSTEM
MODEL:WBS-010
We continue to be committed to provide you tools with competitive price.
"Save Half", "Half Price" or any other similar expressions used by us only represents an
estimate of savings you might benefit from buying certain tools with us compared to the major
top brands and does not necessarily mean to cover all categories of tools offered by us. You
are kindly reminded to verify carefully when you are placing an order with us if you are
actually saving half in comparison with the top major brands.
Advertisement
Related Manuals for VEVOR WBS-010
Summary of Contents for VEVOR WBS-010
- Page 1 Technical Support and E-Warranty Certificate www.vevor.com/support WHEEL ALIGNMENT SYSTEM MODEL:WBS-010 We continue to be committed to provide you tools with competitive price. "Save Half", "Half Price" or any other similar expressions used by us only represents an estimate of savings you might benefit from buying certain tools with us compared to the major top brands and does not necessarily mean to cover all categories of tools offered by us.
- Page 2 This is the original instruction, please read all manual instructions carefully before operating. VEVOR reserves a clear interpretation of our user manual. The appearance of the product shall be subject to the product you received. Please forgive us that we won't inform you again if there are any technology or software updates on our product.
- Page 3 Assembly Diagram of this manual. Unwrap and separate all parts in a clean work area. Please keep small spare parts out of children's reach. SAVE THESE INSTRUCTIONS PRODUCT SPECIFICATIONS: Model (mm) (mm) (mm) WBS-010 228.6 38.1 - 2 -...
- Page 4 PACKAGE INCLUDE Components Picture Q’ty Tape measure 2pcs Hexagon stud 4pcs black thumb screws 8pcs flat washer 8pcs rubber grippers 4pcs magnet 2pcs Angle comparison table 1pcs SIMPLE INSTRUCTION Step 1: Install support studs. Use the 8 thumb screws to attach them to the plates as desired.Place 8 flat pads on the thumb screw and prop screw sides as shown.
- Page 5 Step 2: Bolt on the upper contact point. One washer sits between the chassis of the gauge and the threaded shaft. The small backing plate threads on the backside . To adjust the position of the contact point only the threaded shaft needs to be turned, the chassis of the gauge will prevent the backing plate from turning.
- Page 6 Step 2: Extend tape measures Run the tape measures underneath the car as shown, 80 inches should be enough. Step 3: Adjust stand-offs Use the same procedure as shown in step 1 to fit the other toe plate on the opposite side of the vehicle and place the tape measures into the tape holder slots.
- Page 7 TOE PLATE DEGREES TO INCH CONVERSION CHART Example: If the vehicle specs specify 0.4 degrees the toe should be half way between 1/8”and 3/16” measured by the toe plates. Degrees 0.16 0.32 0.48 0.64 0.96 Specification Equivalent 1/16” 1/8” 3/16” 1/4”...
- Page 8 Technical Support and E-Warranty Certificate www.vevor.com/support...
Need help?
Do you have a question about the WBS-010 and is the answer not in the manual?
Questions and answers