Woodward TecJet 50 Plus Installation Procedure Supplement

TecJet™ 50 Plus / TecJet™ 50 Plus Precision Flow
This document contains the following information:
•
Where to obtain the complete TecJet 50 Plus technical manual
•
Important Definitions
•
Regulatory Compliance and Declarations
•
Contacting Woodward or a Woodward Channel Partner
See Manual 26219 for complete installation, operation, maintenance, and certification information.
Publications can be found on our website at
Important Definitions
This is the safety alert symbol. It is used to alert you to potential personal injury hazards. Obey all safety
messages that follow this symbol to avoid possible injury or death.
•
DANGER—Indicates a hazardous situation which, if not avoided, will result in death or serious injury.
•
WARNING—Indicates a hazardous situation which, if not avoided, could result in death or serious injury.
•
CAUTION—Indicates a hazardous situation which, if not avoided, could result in minor or moderate injury.
•
NOTICE—Indicates a hazard that could result in property damage only (including damage to the control).
•
IMPORTANT—Designates an operating tip or maintenance suggestion.
Lockout/Tagout
LOTO
Overspeed /
Overtemperature /
Overpressure
Read this entire manual and all other publications pertaining to the work to be performed before
installing, operating, or servicing this equipment. Practice all plant and safety instructions and
precautions. Failure to follow instructions can cause personal injury and/or property damage.
This publication may have been revised or updated since this copy was produced. To verify that
you have the latest revision, check manual
Revision Status & Distribution Restrictions, on the publications page of the Woodward website:
The latest version of most publications is available on the publications page. If your publication is
not there, please contact your customer service representative to get the latest copy.
Manual 26809
(Revision E, 09/2022)
Ensure that personnel are fully trained on LOTO procedures prior to
attempting to replace or service equipment on a "live" running engine. All
safety protective systems (overspeed, over temperature, overpressure, etc.)
must be in proper operational condition prior to the start or operation of a
running engine. Personnel should be equipped with appropriate personal
protective equipment to minimize the potential for injury due to release of
hot hydraulic fluids, exposure to hot surfaces and/or moving parts, or any
moving parts that may be activated and are located in the area of control of
the unit.
The engine, turbine, or other type of prime mover should be equipped with an
overspeed shutdown device to protect against runaway or damage to the prime
mover with possible personal injury, loss of life, or property damage.
The overspeed shutdown device must be totally independent of the prime mover
control system. An overtemperature or overpressure shutdown device may also
be needed for safety, as appropriate.
www.woodward.com/publications
Installation Procedure Supplement
www.woodward.com/publications
26455
, Customer Publication Cross Reference and
Woodward Publication 26809 page 1
.