Table of Contents
Advertisement
Selecting Access Control Options
Click Submit to store the new access control rules in the ACL file.
20.
NOTE
Repeat all steps above for each server instance you wish to establish access
21.
control for.
When finished, click Apply.
22.
Select hard start /restart or dynamically apply.
23.
ACL settings can also be enabled on a per virtual server basis. To learn how this is
done, see "Editing Access Control Lists for Virtual Servers," on page 203.
Selecting Access Control Options
The following sections describe the various options that you can select when
setting access control. For the Administration Server, the first two lines are set as
defaults and cannot be edited.
Setting the Action
You can specify the action the server takes when a request matches the access
control rule.
•
Allow means users or systems can access the requested resource
•
Deny means users or systems cannot access the resource
The server goes through the list of access control expressions (ACEs) to determine
the access permissions. For example, the first ACE is usually to deny everyone. If
the first ACE is set to "continue," the server checks the second ACE in the list, and
if it matches, the next ACE is used. If continue is not checked, everyone would be
denied access to the resource. The server continues down the list until it reaches
either an ACE that doesn't match, or that matches but is set to not continue. The
last matching ACE determines if access is allowed or denied.
Specifying Users and Groups
With user and group authentication, users are prompted to enter a username and
password before they can access the resource specified in the access control rule.
180
Netscape Enterprise Server Administrator's Guide • November 2001
Clicking Revert will remove all of the settings you've just created.
Advertisement
Table of Contents
