Table of Contents
Advertisement
Adding and Using Thread Pools
You can also edit the thread pool settings in vsclass.
virtual server class name.
A thread pool appears in vsclass.
Init fn="thread-pool-init" name=name_of_the_pool MaxThreads=n
MinThreads=n QueueSize=n StackSize=n
Use the following parameters to change the pool:
QueueSize
Windows NT users can always edit the settings for the native pool using the Server
Manager.
Using Thread Pools
After you've set up a thread pool, use it by designating it as the thread pool for a
specific service.
To configure a thread pool, go to the Server Manager Preferences tab and select
Thread Pool. Once a thread pool is configured, then the Thread Pool list will show
the thread pool available to be used for the specific service you've
You can also designate a thread pool by using the
load-modules
name.
pool="name_of_pool"
In addition, you can use the
that NSAPI function runs on the pool you specify.
158
Netscape Enterprise Server Administrator's Guide • November 2001
, and
.
StackSize
function in vsclass.
pool
obj.conf
as follows:
obj.conf
MinThreads
pool
, where vsclass is the virtual server class
obj.conf
parameter on any NSAPI function so that only
, where vsclass is the
,
,
MaxThreads
designated.
parameter of the
Advertisement
Table of Contents
