Table of Contents
Advertisement
Your master Administration Server now attempts to contact the remote server.
This can take a few minutes. You will receive a message confirming the server
is added to the cluster.
Click OK.
8.
NOTE
Modifying Server Information
Use the Modify Server option only to update slave administration port
information, after it has been changed on the slave server. If you change the port
number of a remote Administration Server in your cluster, you also need to modify
the information about that Administration Server stored in the cluster. Any other
changes to the slave administration server require you to delete the server, and
then add it back into the cluster after the changes have been made.
The remote administration servers will not be affected by modification to the
master cluster database, unless their files have been transferred through Cluster
Control.
To modify information about a server in a cluster, perform the following steps:
Go to the master Administration Server and choose the Cluster Mgmt tab.
1.
Click the Modify Server link.
2.
All servers appear listed by their unique server identifier.
Select the server or server to modify by:
3.
Click Reset to undo all selections.
Enter the new port number.
4.
Click OK.
5.
If you have two or more servers on different computers that use the
same identifier, the server identifier and the hostname for each
computer are displayed. When both server identifier and
hostnames are the same, the port number is also displayed.
Checking a specific server
Clicking Select All
Modifying Server Information
Chapter 6
Managing Server Clusters
141
Advertisement
Table of Contents
