Red Hat ENTERPRISE LINUX 5 - DEPLOYMENT Deployment Manual page 744

Chapter 43. Securing Your Network
43.9.3.4.4. Additional Match Option Modules
Additional match options are available through modules loaded by the iptables command.
To use a match option module, load the module by name using the -m <module-name>, where
<module-name> is the name of the module.
Many modules are available by default. You can also create modules to provide additional
functionality.
The following is a partial list of the most commonly used modules:
• limit module — Places limits on how many packets are matched to a particular rule.
When used in conjunction with the LOG target, the limit module can prevent a flood of matching
packets from filling up the system log with repetitive messages or using up system resources.
Section 43.9.3.5, "Target Options"
Refer to
The limit module enables the following options:
• --limit — Sets the maximum number of matches for a particular time period, specified as a
<value>/<period> pair. For example, using --limit 5/hour allows five rule matches per
hour.
Periods can be specified in seconds, minutes, hours, or days.
If a number and time modifier are not used, the default value of 3/hour is assumed.
• --limit-burst — Sets a limit on the number of packets able to match a rule at one time.
This option is specified as an integer and should be used in conjunction with the --limit option.
If no value is specified, the default value of five (5) is assumed.
• state module — Enables state matching.
The state module enables the following options:
• --state — match a packet with the following connection states:
• ESTABLISHED — The matching packet is associated with other packets in an established
connection. You need to accept this state if you want to maintain a connection between a client
and a server.
• INVALID — The matching packet cannot be tied to a known connection.
• NEW — The matching packet is either creating a new connection or is part of a two-way
connection not previously seen. You need to accept this state if you want to allow new
connections to a service.
• RELATED — The matching packet is starting a new connection related in some way to an
existing connection. An example of this is FTP, which uses one connection for control traffic
(port 21), and a separate connection for data transfer (port 20).
These connection states can be used in combination with one another by separating them with
commas, such as -m state --state INVALID,NEW.
718
for more information about the LOG target.