Overview Of Tools - Red Hat ENTERPRISE LINUX 5 - DEPLOYMENT Deployment Manual

Chapter 39.
OProfile
OProfile is a low overhead, system-wide performance monitoring tool. It uses the performance
monitoring hardware on the processor to retrieve information about the kernel and executables on the
system, such as when memory is referenced, the number of L2 cache requests, and the number of
hardware interrupts received. On a Red Hat Enterprise Linux system, the oprofile RPM package
must be installed to use this tool.
Many processors include dedicated performance monitoring hardware. This hardware makes it
possible to detect when certain events happen (such as the requested data not being in cache).
The hardware normally takes the form of one or more counters that are incremented each time
an event takes place. When the counter value, essentially rolls over, an interrupt is generated,
making it possible to control the amount of detail (and therefore, overhead) produced by performance
monitoring.
OProfile uses this hardware (or a timer-based substitute in cases where performance monitoring
hardware is not present) to collect samples of performance-related data each time a counter
generates an interrupt. These samples are periodically written out to disk; later, the data contained
in these samples can then be used to generate reports on system-level and application-level
performance.
OProfile is a useful tool, but be aware of some limitations when using it:
• Use of shared libraries — Samples for code in shared libraries are not attributed to the particular
application unless the --separate=library option is used.
• Performance monitoring samples are inexact — When a performance monitoring register triggers a
sample, the interrupt handling is not precise like a divide by zero exception. Due to the out-of-order
execution of instructions by the processor, the sample may be recorded on a nearby instruction.
• opreport does not associate samples for inline functions' properly — opreport uses a simple
address range mechanism to determine which function an address is in. Inline function samples are
not attributed to the inline function but rather to the function the inline function was inserted into.
• OProfile accumulates data from multiple runs — OProfile is a system-wide profiler and expects
processes to start up and shut down multiple times. Thus, samples from multiple runs accumulate.
Use the command opcontrol --reset to clear out the samples from previous runs.
• Non-CPU-limited performance problems — OProfile is oriented to finding problems with CPU-limited
processes. OProfile does not identify processes that are asleep because they are waiting on locks
or for some other event to occur (for example an I/O device to finish an operation).

39.1. Overview of Tools

Table 39.1, "OProfile Commands"
package.
Command
ophelp
provides a brief overview of the tools provided with the oprofile
Description
Displays available events for the system's processor along with a brief
description of each.
535