AMX CAFE DUET STANDARD NETLINX API (SNAPI) COMPONENTS AND LISTENERS Instruction Manual page 76

Component Functions:
Name: Channel: Level: Command:
getLightLevel(index)
isLightOn(1)
isLightOn(10)
isLightOn(11)
isLightOn(12)
isLightOn(13)
isLightOn(14)
isLightOn(15)
isLightOn(16)
isLightOn(17)
isLightOn(18)
isLightOn(19)
isLightOn(2)
isLightOn(20)
isLightOn(3)
isLightOn(4)
isLightOn(5)
isLightOn(6)
isLightOn(7)
isLightOn(8)
isLightOn(9)
isLightOn(index)
removeLightCompo-
nent(index)
removeLightCompo-
nent(lightAddress)
setLight-
Level(index,level)
setLight-
Level(index,level,sec-
onds)
setLightOn(index)
70
Constant:
?LIGHTLEVEL-<index>
?LIGHTSTATE-1
?LIGHTSTATE-10
?LIGHTSTATE-11
?LIGHTSTATE-12
?LIGHTSTATE-13
?LIGHTSTATE-14
?LIGHTSTATE-15
?LIGHTSTATE-16
?LIGHTSTATE-17
?LIGHTSTATE-18
?LIGHTSTATE-19
?LIGHTSTATE-2
?LIGHTSTATE-20
?LIGHTSTATE-3
?LIGHTSTATE-4
?LIGHTSTATE-5
?LIGHTSTATE-6
?LIGHTSTATE-7
?LIGHTSTATE-8
?LIGHTSTATE-9
?LIGHTSTATE-<index>
LIGHTREMOVEIDX-<index>
LIGHTREMOVEADDR-<address>
LIGHTLEVEL-<index>,<level>
LIGHTLEVEL-
<index>,<level>,<time>
LIGHTSTATE-<index>
Notes:
Query for the level of a light for the light at index <index>, responds with LIGHTLEVEL-
<index>,<level> where <level> is 0-255. This command is relevant for light loads only.
Query status of Light Preset 1
Query status of Light Preset 10
Query status of Light Preset 11
Query status of Light Preset 12
Query status of Light Preset 13
Query status of Light Preset 14
Query status of Light Preset 15
Query status of Light Preset 16
Query status of Light Preset 17
Query status of Light Preset 18
Query status of Light Preset 19
Query status of Light Preset 2
Query status of Light Preset 20
Query status of Light Preset 3
Query status of Light Preset 4
Query status of Light Preset 5
Query status of Light Preset 6
Query status of Light Preset 7
Query status of Light Preset 8
Query status of Light Preset 9
Query for the state of a light for the light at index <index>, responds with LIGHTSTATE-
<index>,<state> where <state> is ON or OFF. This command is relevant for light loads,
presets, and scenes.
Remove the light at index <index>, where <index> is 1 through x and x is the maximum
supported light index (see specific module documentation)
Remove the light with address <address>, where <address> is a light address
Set the level of a light for the light at index <index>, <level> where <level> is 0-255.
This command is relevant for light loads only.
Set the level of a light for the light at index <index> in <time>, <level> where <level> is
0-255 and <time> is in seconds. This command is relevant for light loads only.
Set the light ON at index <index>. This command is relevant for light loads, presets,
and scenes.
Standard NetLinx API (SNAPI) R 1.8.0