Installing Touch Panels And A Cb-Tp3 Backbox (Plasterboard) - AMX 10.4 TOUCH PANELS (G3 FIRMWARE) Instruction Manual

Installation
9. Fasten the CB-TP3 to the solid surface using the supplied mounting screws. The touch panel
must be installed with the release slot at the bottom.
10. Connect the AXlink, RS-232, and optional graphic/video wiring to the touch panel.
11. Test the connection by reconnecting the AXlink connector to the Central Controller and the
optional video wiring to the video source. The panel beeps on power-up. Before continuing,
disconnect all connections until panel installation is complete.
12. Fasten the touch panel to the CB-TP3 using the #6-32 screws supplied with the panel.
13. Place the Decor-style faceplate onto the bezel. You can also secure the faceplate to the bezel
using the four Phillips flathead security screws.
14. Remove the backing from the adhesive tape strips; press the engraved overlay onto the
faceplate. Once attached to the faceplate, the security screws cannot be replaced without
removing the overlay.
15. Reconnect the AXlink wiring to the Central Controller, RS-232 wiring to the mouse (if used),
and optional graphic/video wiring to the source equipment. The touch panel will beep on
power-up.

Installing touch panels and a CB-TP3 Backbox (plasterboard)

FIG. 4 shows the AXD-CA10/PB and CB-TP3 Backbox for plasterboard.
CB-TP3 Unimount
Backbox enclosure
FIG. 4 AXD-CA10/PB and CB-TP3 Backbox (plasterboard)
1. Cut out the surface using the dimensions shown in FIG. 5.
2. Carefully insert a flat-blade screwdriver into the release slot on the touch panel's faceplate and
remove the engraved overlay.
3. Lay the touch panel facedown onto a soft cloth and remove the screws from the low-profile
Backbox. Remove the Backbox and discard.
4. Place the CB-TP3 into the cutout and mark the threaded insert positions (FIG. 5).
6
Expansion clips
Knockout
Plasterboard surface mounting flanges
AXD-CA10/PB
faceplate
Engraved overlay
10.4" Touch Panels