Figure 1-9 Installing A Pcmcia Cover On An Scm - Cisco CSS11501 - 100Mbps Ethernet Load Balancing Device Hardware Installation Manual

Chapter 1 Unpacking and Installing the CSS
8.
Figure 1-9
9.
10.
78-13884-06
Optionally, you can install the PCMCIA cover to the front of the disk slots
and secure it with its two spring-loaded screws, as shown in
cover protects the disks in the SCM.
Installing a PCMCIA Cover on an SCM
M AN AG EM
EN T
10 BA SE -T
LI NK /A CT
ST AT US DU PL EX
PC MC IA
SL OT 1
SL OT 0
Reboot the CSS to initialize the passive SCM.
To copy the boot configuration from the active SCM to the passive SCM, use
the passive sync command in boot configuration mode. For more
information, refer to the Cisco Content Services Switch Administration
Guide.
Cisco 11500 Series Content Services Switch Hardware Installation Guide
GE 1
LI NK
GE 2
LI NK
CO NS OL E
Installing a CSS Module
Figure 1-9. The
1-27