Configuring The Downstream Cable Modem Interface; Activating Downstream Cable Address Resolution Protocol Requests - Cisco 7246VXR - uBR Router Software Configuration Manual

Configuring the Downstream Cable Modem Interface

Configuring the Downstream Cable Modem Interface
These configurations are required. The first step in configuring the Cisco CM interface is to configure
the downstream cable interface. Configuring the downstream cable interface consists of the following
procedures:
Task
"Activating Downstream Cable
Address Resolution Protocol
Requests" section on page 3-2
"Activating Downstream Ports"
section on page 3-3
"Assigning the Downstream
Channel ID" section on page 3-5
"Configuring Downstream Rate
Limiting and Traffic Shaping"
section on page 3-6
"Setting the Downstream Helper
Address" section on page 3-7
"Setting the Downstream
Interleave Depth" section on
page 3-8
"Setting the Downstream
Modulation" section on page 3-8
"Setting the Downstream MPEG
Framing Format" section on
page 3-9
"Setting Downstream Traffic
Shaping" section on page 3-10
In most applications, default values for the commands used in these configuration steps are adequate to
Note
configure the Cisco uBR7200 series router. You do not need to specify individual parameters unless you
want to deviate from system defaults.
For information on other configuration options, refer to the
Guide

Activating Downstream Cable Address Resolution Protocol Requests

This configuration is required. Address Resolution Protocol (ARP) is an Internet protocol used to map
IP addresses to MAC addresses on computers and other equipment installed in a network. You must
activate ARP requests on the cable interface so that the Cisco uBR7200 series CMTS can perform IP
address resolution on the downstream path.
Cisco uBR7200 Series Universal Broadband Router Software Configuration Guide
3-2
on Cisco.com.
Chapter 3
Description
Provides instructions to activate ARP requests on the cable
interface so that the Cisco uBR7200 series CMTS can perform IP
address resolution on the downstream path.
Provides instructions to activate and verify a downstream port on
a cable interface card for digital data transmissions over the
HFC network.
Provides instructions to assign and verify a numeric channel ID to
the downstream port on the Cisco cable interface line card.
Provides instructions for using the cable downstream rate-limit
token-bucket command, which configures rate limiting and traffic
shaping on the downstream channel.
Provides instructions to specify an IP address of a Dynamic Host
Configuration Protocol (DHCP) server where User Datagram
Protocol (UDP) broadcast packets will be sent.
Provides instructions to set the downstream interleave depth in
milliseconds for the downstream port on the Cisco cable interface
line card.
Provides instructions to define the speed in symbols per second at
which data travels downstream to the subscriber's CM.
Provides instructions to set and verify the downstream MPEG
framing format, which must be compatible with DOCSIS
specifications and your local cable plant operations.
Provides instructions to use the token bucket policing algorithm
with traffic shaping options or the weighted discard algorithm to
buffer, shape, or discard packets that exceed a set bandwidth.
Cisco IOS CMTS Cable Command Reference
Configuring Cable Modem Interface Features
OL-2239-03