Toshiba SD-H400-S-TU Installation Manual page 67

( Troubleshooting
• You may consider optimizing the IR Control connection as described on page 14.
Press the TiVo button to go to riVo Central, then select Messages & Setup, then
Settings, then Channels, then Channel Changing, then IR cable. Verify the IR code
you chose during Guided Setup. See page 14 for more on choosing an IR code.
Try using the cable or satellite box's remote to change the channel. Ifit doesn't work,
contact the manufacturer or service provider for assistance.
If you have a satellite box and used the Serial Control cable:
• Make sure the satellite box is turned on.
• Verify that the Serial Control cable is plugged into the data connector on the satellite
box and into the Channel Change-Serial connector on the back of the SD-H400.
• Unplug the satellite box from the wall, then plug it back in. Then
try
changing
channels with the riVo remote again.
Try using the cable or satellite box's remote to change the channel. If it doesn't work,
contact the manufacturer or service provider for assistance.
You may have incorrectly specified the type of program guide for your DlRECTV
satellite receiver. There are two types of program guides: MPG (Master Program
Guide) and APG (Advanced Program Guide). First, unplug the power cord for the
satellite receiver and plug it back in. Next, go to TiVo Central, then Messages &
Setup, then Settings, then Channels, then Channel Changing. On the Satellite Channel
Changing screen, if you originally selected Serial-MPG, change your selection to
Serial-APG. (If you originally selected Serial-APG, change it to Serial-MPG.) You
can also check the manual for your satellite receiver (as well as the satellite receiver's
system setup screen) for information on the type of program guide it uses.
53