Peripheral - TYAN TOMCAT I II Manual

5.5 Peripheral

w w Programming Mode
When set to manual, you can customize all the settings below.
When set to auto, they system will automatically configure all the ports.
The default is Manual.
w w OnBoard FDC
This option lets you enable or disable the onboard floppy disk controller.
The default is enabled.
w w Serial Port 1
This option lets you configure the address of serial port 1. The options
are 3F8h, 3E8h, 2E8h or disabled.
The default is 3F8h.
w w Serial Port 2
This option lets you configure the address of serial port 2. The options
are 2F8h, 3E8h, 2E8h and disabled.
The default is 2F8h.
w w Parallel Port
This option lets you configure the address of the onboard parallel port.
The options are 3BCh, 378h, 278h or disabled.
The default is 378h.
w w Parallel Port Mode
This option lets you configure the mode that the onboard parallel port
will function in. The options are Extended or Normal.
The default is Extended.
w w IRQ Active
This options lets you set the IRQ trigger. The options are High or Low.
The default should be used in most cases.
The default is High.
S1562-001-01 55