TYAN TOMCAT I II Manual page 66

4E Manufacturing
POST loop or
display messages
4F Security check
50 Write CMOS
51 PRE-boot enable
52 Initialize Option
ROM's
53 Initialize time value Initialize time value in 40h: BIOS area
60 Setup Virus Protect Setup virus protect according to setup
61 Set Boot Speed
62 Setup NumLock
63 Boot Attempt
B0 Spurious
B1 Unclaimed NMI
E1-EF Setup Pages
S1562-001-01
Reboot if manufacturing POST loop pin is set. Otherwise
display any messages(i.e. non fatal errors that were detected
during POST) and enter setup
Ask password security (optional)
Write all CMOS values back to RAM and clear screen
Enable parity checker, enable NMI and enable cache before
boot
Initialize any option ROM's present for C8000h to EFFFFh.
When FSCAN option is enabled, will initialize from C8000h
to F7FFFh.
Set system speed for boot
Set up NumLock status according to setup
Set low stack. Boot via INT 19h
If interrupt occurs in protected mode
If unmasked NMI occurs, display Press F1 to disable NMI or
F2 to reboot
E1-Page 1, E2-Page 2, etc.
66