Peripheral Setup - TYAN S1830 User Manual

Chapter 4
BIOS Configuration
BIOS Devnode for Shadow RAM
This option is used for some add-on card ROMs which do not claim the
correct memory range that they occupy. The settings are Disabled or Enabled.

Peripheral Setup

Peripheral Setup options are displayed by choosing Peripheral Setup from the
AMIBIOS Setup main menu. All Peripheral Setup options are described here.
Power Interruption
OnBoard FDC
OnBoard Serial Port1
OnBoard Serial Port2
Serial Port2 Mode
**IR Duplex Mode
**Receiver Pin
OnBoard Parallel Port
Parallel Port Mode
**EPP Version
Parallel Port IRQ
**Parallel Port DMA Channel
OnBoard IDE
** Setting is not Selectable
Power Interruption
The settings are Enabled or Disabled.
Onboard FDC
Set this option to Enabled to enable the floppy drive controller on the
motherboard. The settings are Auto, Enabled, or Disabled.
Onboard Serial Port1
This option specifies the base I/O port address of serial port 1. The settings
are Auto, Disabled, 3F8h, 2F8h, 3E8h, or 2E8h.
Onboard Serial Port2
This option specifies the base I/O port address of serial port 2. The settings
are Auto, Disabled, 3F8h, 2F8h, 3E8h, or 2E8h.
Fail-Safe Default
Disabled
Auto
3F8h
2F8h
Normal
N/A
IRRX1
378
Normal
N/A
7
N/A
Both
56
Optimal Default
Disabled
Auto
3F8h
2F8h
Normal
N/A
IRRX1
378
Normal
N/A
7
N/A
Both
http://www.tyan.com