TYAN TIGERCUB ATX Manual page 24

Chapter 2
Board Installation
heat sink mounting bracket, gently press the
ends of the locks inward and pull.
Lock the heat sink mount to the board by
inserting the two mounting locks (Figure 19)
into the pins of the heat sink mounting bracket
which are now below the mainboard. There will
be a click when the locks are securely fastened.
Removing the CPU.
To remove the CPU, move the locks to the center of the CPU. A click
will be heard when the CPU has been unlocked. Gently pull up on the
CPU, taking care not to bend the motherboard or the CPU retention
module.
To remove the lock from the retention module, gently press the ends of
the locks inward and pull.
You are done.
Other than checking the jumper settings and cable connections and
putting the case back on, you are done. Installing a new motherboard
may sound difficult, but by following these directions, you should have
a fairly uneventful time installing our products. If you do encounter
problems, your dealer will be able to help you, or you can consult one
of our many technical support resources (see page 8).
24
Figure 19
http://www.tyan.com