TYAN TIGERCUB ATX Manual page 13

Next, connect your IDE cables (if you're using IDE hard drives).
Figure 3
The colored stripe on the cable (pin 1) should face towards the battery.
In Figure 3 you can see how the IDE cables should look when they are
connected to your hard
drive. Notice how Pin 1
(denoted by a red
stripe) is connected so
that it is next to the
power connector of the
drive. In most cases,
this is the proper way of
connecting your IDE
Pin 1
cable to the hard drive.
Figure 4 shows the IDE
cable properly con-
nected to the
motherboard.
Contact your hard disk
drive manufacturer or
documentation for more
Figure 4
http://www.tyan.com
13