TYAN TIGERCUB ATX Manual page 22

Chapter 2
Board Installation
Installing the Active Processor
When the retention module is securely in-
stalled, you are ready to plug in the CPU.
Press down firmly on the CPU until you hear
a "click" (see Figure 15). This clicking sound
indicates that the CPU is fully locked into the
retention module. If you have an active pro-
cessor, you will also need to connect the
CPU's cooling fan cable to the cooling fan power connector on the board.
Figure 15
Locate the cooling fan connector (e.g. FAN1) on the
motherboard. Plug the CPU's cooling fan cable into
the cooling fan connector on the board. There will be a
plastic clip assembly similar to that of the ATX power
connector that will force you to connect the fan cable
correctly (see Figure 16 below).
Figure 16
22
Figure 14
http://www.tyan.com