Removing The Cpu - TYAN THUNDER 100 Manual

Insert the heat sink mount into the holes on the motherboard. When the
bracket is properly inserted into the holes on the motherboard, you will hear a
clicking noise.
Align the CPU with the CPU retention module. Make sure the heat sink is lined
up with the heat sink mount bracket. If you put the CPU in the wrong way, you
may damage the CPU, the motherboard, and/or the CPU socket. Slowly press
down on the CPU module until the CPU locks into place. You will hear a
clicking noise when the CPU is locked securely into the module.
The heat sink lock (Figure 18) has four
notches which will correspond to the
four pins on the heat sink mounting
bracket. Gently slide the lock between
the heat sink and the heat sink mount-
ing bracket until both sides of the lock are firmly secured. A clicking sound will
be heard when the lock is securely fastened to the heat sink mounting bracket.
To remove the lock from the heat sink mounting
bracket, gently press the ends of the locks inward and
pull.
Lock the heat sink mount to the board by inserting
the two mounting locks (Figure 19) into the pins of
the heat sink mounting bracket which are now below
the mainboard. There will be a click when the locks are
securely fastened.

Removing the CPU.

To remove the CPU, move the locks to the center of the CPU. A click will be
heard when the CPU has been unlocked. Gently pull up on the CPU, taking
care not to bend the motherboard or the CPU retention module.
To remove the lock from the retention module, gently press the ends of the
locks inward and pull.
S1836 Thunder 100
Figure 17
23
pins and the holes in the mother-
board will determine the correct
orientation. When the bracket is
correctly installed, the four pins
on top will be right next to the
Pentium II CPU slot.
Figure 18
Figure 19