Other Operating Systems - TYAN THUNDER 100 Manual

Chapter 3
Onboard Resource Settings
double-click Network Neighborhood, try the suggestions here first, then turn
to the "Troubleshooting" section if necessary.
• Make sure you're using the drivers that are on the drivers diskette that ships
with this adapter.
• Make sure the driver is loaded and the protocols are bound. Check Device
Properties list for trouble indicators (an X or ! symbol).
• Test the adapter. Start PROSet (see page 43) and click Test to run diagnostics.
• Check with your LAN administrator — you may need to install supplemental
networking software.
Windows 98
Windows 98 will automatically configure and install the drivers for the Ethernet
chip upon fresh installation.
NetWare Server, Client 32, UNIX, OS/2, Banyan, and

Other Operating Systems

For these, refer to our online documents. On a DOS computer, view the
appropriate README file for information on installing your network driver. To
view the README files, insert the Intel Configuration and Drivers disk into a
drive, switch to that drive, and type: SETUP /README. Look through the
selection called "Installing EtherExpress PRO/100B TX PCI Adapter Drivers"
for the operating system you need.
Installing Multiple Adapters
All users: The adapter's 12-digit, hexadecimal Ethernet address is on a sticker
on the motherboard near the LAN controller chip. The Ethernet address is
sometimes called the node address or the MAC address. Note that the PCI slot
number may not correspond with the physical connector in your computer.
Install only one active WOL adapter per computer. You can install additional,
non-WOL adapters.
NetWare users: The server drivers use the PCI slot number to identify each
installed adapter. You can correlate the PCI slot number to the adapter by using
the Ethernet address that is printed on a label on the adapter. Run Setup from
the Intel disk to view the Ethernet address and slot number for each installed
42
http://www.tyan.com