Chapter 2: Board Installation - TYAN TEMPEST I5000PT Manual

Chapter 2: Board Installation

You are now ready to install your motherboard. The mounting-hole pattern of the Tempest i5000PT
(S5383) matches the E-ATX specification. Before continuing with installation, confirm that your
chassis supports an E-ATX
How to install our products right.... the first time!
The first thing you should do is to read this user's manual because the important information
contained will make configuration and setup much easier. Here are some precautions you should
take when installing your motherboard:
(1) Ground yourself properly before removing your motherboard from the antistatic bag.
Unplug the power from your computer power supply and then touch a safely grounded
object to release static charge (i.e. power supply case). For the safest conditions, Tyan
recommends wearing a static safety wrist strap.
(2) Hold the motherboard by its edges and do not touch the bottom of the board, or flex the
board in any way.
(3) Avoid touching the motherboard components, IC chips, connectors, memory modules,
and leads.
(4) Place the motherboard on a grounded antistatic surface or on the antistatic bag that the
board was shipped in.
(5) Inspect the board for damage.
The following pages include details on how to install your motherboard into your chassis, as well as
installing the processor, memory, disk drives and cables.
NOTE DO NOT APPLY POWER TO THE BOARD IF IT HAS BEEN DAMAGED
motherboard.
http://www.TYAN.com
8