Bios Advanced Menu - TYAN TEMPEST I5000PT Manual

3.3 BIOS Advanced Menu

This section facilitates configuring advanced BIOS options for your system.
Main
Installed O/S:
Reset Configuration Data:
Large Disk Access Mode:
Advanced Chipset Control
Advanced Processor Options
I/O Device Configuration
Hardware Monitor
DMI Event Logging
Legacy USB Support:
IPMI
Console Redirection
F1 Help
Setup Defaults
Esc Exit
Previous Values
Installed OS
Select the operating system installed on the PC.
Note: An incorrect setting can cause the operating system to behave unpredictably.
Win2K/XP / Other
Reset Configuration Data
If you install a new piece of hardware or modify your computer's hardware configuration,
the BIOS will automatically detect the changes and reconfigure the ESCD (Extended
SystemConfiguration Data). Therefore, there is usually no need to manually force the
BIOS to reconfigure the ESCD.
However, sometimes, the BIOS may not be able to detect the hardware changes. A
serious resource conflict may occur and the operating system may not even boot as a
result. This is where the Reset Configuration Data BIOS feature comes in.
This BIOS feature allows you to manually force the BIOS to clear the previously saved
ESCD data and reconfigure the settings. All you need to do is enable this BIOS feature
and then reboot your computer. The new ESCD should resolve the conflict and allow the
operating system to load normally.
Please note that the BIOS will automatically reset it to the default setting of No after
reconfiguring the new ESCD. So, there is no need for you to manually disable this
feature after rebooting.
Yes / No
Large Disk Access Mode
This option determines whether a hard drive with more than 1024 cylinders, more than
PhoenixBIOS Setup Utility
Advanced
[Win2K/XP]
[No]
[DOS]
[Enabled]
↑↓
Select Item
← →
Select Menu
http://www.TYAN.com
Power
Item Specific Help
Select one of the ACPI
power states: S1 or S3.
If selected, the
corresponding power
state will support.
-/+ Change Values
Enter Select
45
Boot Exit
F9
Sub-Menu F10