Installing Hood - Desa Comfort Glow CGEFP33PR Owner's Operation And Installation Manual

UNVENTED PROPANE/LP GAS FIREPLACE
INSTALLATION
Continued
Mantel Clearances for Built-In
Installation
If placing mantel above built-in fireplace,
you must meet minimum clearance between
mantel shelf and top of fireplace opening.
Wall board or facing
material (above
firebox) may be of
combustible material, 10"
including decorative
8"
mantel ornaments or
other similar projec- 6"
tions off of the facing
1 /2
2
material.
Framing
Material
Firebox
Wire-mesh
Screen
Figure 36 - Minimum Mantel Clearances for Built-In Installation
NOTICE: Surface temperatures of
adjacent walls and mantels be-
come hot during operation. Walls
and mantels above the firebox
may become hot to the touch. If
installed properly, these tempera-
tures meet the requirement of the
national product standard. Fol-
low all minimum clearances
shown in this manual.
NOTICE: If your installation does
not meet the minimum clearances
shown, you must do one of the
following:
• raise the mantel to an accept-
able height
• remove the mantel
For more information, visit www.desatech.com
Mantel Shelf
"
Noncombustible
Material May
Project Off this
Surface above
the Firebox Hood
13" 16" 19" 21"
Note: All vertical
measurements are
from top of fireplace
Supplied Firebox
hood opening to bottom
Hood Must Be
of mantel shelf.
Used at All Times
These minimum
clearances replace any
other recommended
clearances supplied with
your ANS Z21.11.2
approved gas logs.
ASSEMBLING AND
ATTACHING OPTIONAL
BRASS TRIM
(Included with Mantel
Accessory)
INote: The instructions below show assem-
bling and attaching brass trim to fireplace.
1. Remove packaging from three pieces
of brass trim.
2. Locate four brass screws, two adjust-
ing plates with set screws, and two
shims in the hardware packet.
3. Align shim under adjusting plate as
shown in Figure 37.
4. Slide one end of adjusting plate/shim
in slot on mitered edge of top brass trim
(see Figure 37).
5. Slide other end of adjusting plate/shim
in slot on mitered edge of side brass
trim (see Figure 37).
6.
7.
8.
Side
Brass
Trim
Figure 37 - Assembling Brass Trim
Figure 38 - Attaching Brass Trim to
Fireplace

INSTALLING HOOD

Install hood to top of firebox as shown in
Figure 39. Use 3 Phillips screws provided.
Figure 39 - Installing Hood to Firebox
18
While firmly holding edges of brass trim
together, tighten both set screws on the
adjusting plate with slotted screwdriver.
Repeat steps 1 through 6 for other side.
Tighten trim hanging screws (#10 x
6.25 shoulder) into holes in cabinets.
Place the assembled trim onto fireplace
cabinet. Align hanging notches on trim
with hanging screws on side of fire-
place (see Figure 38). Push trim firmly
into place, sliding hanging notches over
hanging screws.
Set Screws
Adjusting
Plate
Shim
Slot
Mitered Edge
Slot
Assembled
Brass Trim
Top
Brass
Trim
Trim
Hanging
Screws
Hanging
Notches
on Trim
107570