Installing Hood - Desa EFP33NR Owner's Operation And Installation Manual

INSTALLATION
Continued
Adjusting
Side Brass
Plate
Trim
Slot
Mitered Edge
Figure 38 - Assembling Brass Trim
Assembled
Brass Trim
Figure 39 - Attaching Brass Trim to Fireplace (EFP33PR Shown)

INSTALLING HOOD

Install hood to top of firebox as shown in Figure 40. Use 3 Phillips
screws provided.
Figure 40 - Installing Hood to Firebox (EFP33PR Shown)
For more information, visit www.desatech.com
For more information, visit www.desatech.com
108117-01H
Set Screws
Top Brass
Trim
Shim
Slot
Trim
Hanging
Screws
Hanging
Notches
on Trim
Assembling And Attaching Optional Brass Trim (Cont.)
Installing Logs (CGEFP33PR/CGEFP33NR)
INSTALLING LOGS (CGEFP33PR/CGEFP33NR)
WARNING: Failure to position the parts in accor-
dance with these diagrams or failure to use only parts
specifically approved with this heater may result in
property damage or personal injury.
CAUTION: Do not remove the warning and in-
struction labels attached to the heater base assem-
bly. These markings contain important warranty in-
formation.
CAUTION: After installation and periodically there-
after, check to ensure that no flame comes in contact
with any log. With the heater set to HI, check to see if
flames contact any log. If so, reposition logs accord-
ing to the log installation instructions in this manual.
Flames contacting logs will create soot.
Each log is marked with a number. These numbers will help you
identify the log when installing. It is very important to install these
logs exactly as instructed. Do not modify logs. Only use logs
supplied with heater.
1. Locate pegs on the bottom of back log (#1). Slide these pegs into
the holes in the grate base behind the burner (see Figure 41).
2. Place the base of the middle log (#2) in the U-shaped slots of
the grate base in front of the back log. The cutout on the right
of the middle log should fit over the burner (see Figure 42).
Make sure the front of the middle log is resting on the tabs of
the grate base and the cutout area is centered over the burner
"U" bend.
3. Locate the recesses on the back of the front log (#3). Fit these
recesses between the posts of the grate base (see Figure 43,
page 22).
Hole in
Grate
Base
Figure 41 - Installing Back
Log (#1)
INSTALLATION
Installing Hood
Middle
Back
Log
Log
(#2)
(#1)
Tab
Burner
Burner
U-Shaped Slot
Figure 42 - Installing Middle
Log (#2)
21
21
Cutout
"U" Bend