Installing Hood - Desa CGEFP33PRB Owner's Operation And Installation Manual

INSTALLATION
Continued
Wall board or facing
material (above
firebox) may be of
combustible material,
including decorative
mantel ornaments or
other similar projec-
tions off of the facing
material.
Framing
Material
Firebox
Wire-mesh
Screen
Figure 37 - Minimum Mantel Clearances
for Built-In Installation
ASSEMBLING AND ATTACHING
OPTIONAL BRASS TRIM
(Included with Mantel Accessory)
Note: The instructions below show assembling
and attaching brass trim to fireplace.
1. Remove packaging from three pieces of
brass trim.
2. Locate four brass screws, two adjusting
plates with set screws and two shims in the
hardware packet.
3. Align shim under adjusting plate as shown in
Figure 38.
4. Slide one end of adjusting plate/shim in slot on
mitered edge of top brass trim (see Figure 38).
5. Slide other end of adjusting plate/shim in slot on
mitered edge of side brass trim (see Figure 38).
6. While firmly holding edges of brass trim to-
gether, tighten both set screws on the adjusting
plate with slotted screwdriver.
7. Repeat steps 1 through 6 for the other side.
8. Tighten trim hanging screws (#10 x 6.25
shoulder) into holes in cabinets. Place the
assembled trim onto fireplace cabinet. Align
hanging notches on trim with hanging screws
on side of fireplace (see Figure 39). Push trim
firmly into place, sliding hanging notches over
hanging screws.
111245-01C
Mantel Shelf
10"
8"
6"
2 1 /2 "
Noncombustible
Material May
Project Off this
Surface above
the Firebox
13" 16" 19" 21"
Hood
Note: All vertical
measurements are
Supplied
from top of fireplace
Firebox
hood opening to
Hood
bottom of mantel
Must Be
shelf. These minimum
Used at
clearances replace any
All Times
other recommended
clearances supplied
with your ANSI Z21.11.2
approved gas logs.
www.desatech.com
Top Brass Trim
Side Brass
Trim Adjusting
Plate
Slot
Mitered Edge
Figure 38 - Assembling Brass Trim
Assembled
Brass Trim
Figure 39 - Attaching Brass Trim to
Fireplace

INSTALLING HOOD

Install hood to top of firebox as shown in Figure 40.
Use 3 Phillips screws provided.
Figure 40 - Installing Hood to Firebox
Set Screws
Shim
Slot
Trim
Hanging
Screws
Hanging
Notches
on Trim
23