Preparing The Switch For Mounting; Figure 1-4. Removing The Rack Doors - Dell PowerVault 50F Installation And Troubleshooting Manual
Dell powervault 51f 8-port fibre channel switch installation and troubleshooting guide
Hide thumbs
Also See for PowerVault 50F:
- Installation and troubleshooting manual (172 pages) ,
- User manual (42 pages) ,
- Rack installation manual (28 pages)
Table of Contents
Advertisement
support.dell.com
Figure 1-4. Removing the Rack Doors
3.
Perform steps 1 and 2 to remove the back door from the rack.
CAUTION: Store the two doors in an area where they will not fall over while
you install the switch.
Preparing the Switch for Mounting
To prepare the switch for mounting, perform the following steps:
1.
Place the manifold on a clean, flat surface.
2.
Remove the foam spacer by gently pulling upward on the strap marked "Remove
Before Use."
3.
Be sure that no bits of foam remain in the manifold and that the gaskets were not
damaged during extraction of the foam spacer.
Installing the Dell PowerVault 51F Switch
hinge
release
lever
1-7
Advertisement
Table of Contents
