support.dell.com
ifShow
The ifShow command displays a summary of currently running tasks. The display
includes three sections organized by interface:
•
ei — Ethernet 10/100BASE-T port
•
lo — Loopback interface
•
fc — Fibre Channel; this section is omitted if IP over Fibre Channel is not
configured
ipAddrSet
The following example shows the ipAddrSet command, which sets the switch's
Ethernet IP address, Ethernet subnetmask, Fibre Channel IP address, Fibre Channel
subnetmask, and gateway address. The fields are described in Table 4-11.
switch:admin> ipAddrSet
Ethernet IP Address [192.168.90.241]:
Ethernet Subnetmask [none]:
Fibre Channel IP Address [192.168.65.241]:
Fibre Channel Subnetmask [none]:
Gateway Address [192.168.90.1]:
NOTE: Consult your network administrator for the appropriate IP address(es), subnet-
mask(s), and gateway address.
Table 4-11. ipAddrSet Command Field Descriptions
Field
Ethernet IP address
Ethernet subnetmask
Fibre Channel IP address
Fibre Channel
subnetmask
Gateway IP address
Description
The default IP address on a new switch is a tempo-
rary number derived from the switch's world wide
names (WWN). Enter a valid IP address.
The Ethernet subnetmask value. The default subnet-
mask value is none. See your network administrator
for the appropriate subnetmask value to enter here.
The Fibre Channel IP address for the switch. Enter a
valid IP address. (Not currently supported.)
The Fibre Channel subnetmask for the switch. The
default is none.
The gateway IP address. The default gateway address
on a new switch is none. You must enter a valid gate-
way address, if required.
PowerVault 51F Commands 4-21