Name Server - Dell PowerVault 50F Installation And Troubleshooting Manual

3-8 Dell PowerVault 51F 8-Port Fibre Channel Switch Installation and Troubleshooting Guide
2 — Error
3 — Warning
4 — Informational
5 — Debug
See Appendix A, "Error Messages," for more information.
These parameters can be changed via the Telnet command, agtcfgSet or via SNMP .
The sysX parameters can be configured via the SNMPv1 SET command with an
appropriate community. These parameters can be configured via a Telnet connection,
using the command agtcfgSet.
NOTE: A change in the first two configuration parameters takes effect only after
rebooting the switch.

Name Server

The Fibre Channel Protocol (FCP) inquiry data obtained by device probing may now be
obtained from the Name Server by retrieving the port symbolic name.
Common Transport (CT) requests and responses including Name Server are recorded
in the portLog. A typical trace is shown in the following example, where port 4 logs in
to the Name Server and issues command 217 . It receives an Accept (8002).
Jun 15 16:00:21.899
22fffffc,00210413,03000000
Jun 15 16:00:21.899
23210413,00fffffc,02000000
Jun 15 16:00:21.899
02fffffc,00210413,01000000
Jun 15 16:00:21.933
00030217,00210413,00000100
Jun 15 16:00:21.933
Jun 15 16:00:21.933
03210413,00fffffc
tReceive Rx3
tSwitch Tx3
tReceive Rx3
tNSd ctin
tNSd ctout
tNSd Tx3
4 116
4 116
4 52
4 fc
4 fc 00008002
4 0