Table of Contents
Advertisement
Chapter 2
Hardware Installation
This chapter describes the procedures for installing the Intel RAID Controller SRCZCRX. It
contains the following sections:
•
•
•
•
2.1
Requirements
The following items are required to install the RAID controller:
•
•
•
Intel strongly recommends using an uninterruptible power supply (UPS).
2.2
Quick Installation
The following steps are for for experienced computer users/installers. Section 2.3, "Detailed
Installation", contains detailed steps.
1) (Optional, required to enable Write Back Cache) Attach the Battery Backup Unit to the
2) (Optional, required for some chassis) Replace the bracket on the RAID adapter with the
3) Power off the server and all hard disk drives, enclosures, and system components.
4) Follow the instructions in the host system documentation to open the cabinet of the host
5) Check the jumper settings on the RAID adapter.
Intel RAID Controller SRCZCRX
Section 2.1, "Requirements," page 18
Section 2.2, "Quick Installation," page 18
Section 2.3, "Detailed Installation," page 19
Section 2.4, "After You Have Installed the Storage Adapter," page 22
An Intel RAID Controller SRCZCRX
A host computer with the following:
–
Server board with interrupt routing circuitry (INT) routing
–
64-bit, MROMB-enabled PCI expansion slot
Note:
Refer to the Tested Hardware and Operating System List to see which server
boards are supported.
The Resource CD
Note:
All work must be performed at an ESD-safe workstation that meets the
requirements of EIA-625: Requirements for Handling Electrostatic Discharge
Sensitive Devices. All actions must be done following the latest revision of the
IPC-A-610 for ESD recommended practices.
RAID adapter.
low-profile bracket.
Remove the power cord from the server.
system.
18
Advertisement
Table of Contents
