Working With Files; Setting Startup Options; Opening Files - MACROMEDIA COLDFUSION STUDIO 5-USING COLDFUSION 5 STUDIO Use Manual

46

Working with Files

You can use the following procedures to work with files, regardless of their location
(local drive, network drive, or remote server).
Opening and saving files refer to the current directory. For information about how
ColdFusion Studio determines the current directory with two Files tabs, see
the Files Tabs" on page

Setting startup options

To set startup options:
1 Select Options > Settings > Startup to select which files and folders open when
you load the program.
2 Select any of the startup options to:
3 Select one of the following startup folder options to:
4 Click OK to close the Settings dialog box and save your new settings.

Opening files

Use the procedures below to open a file in the file list.
To open a standard file:
1 On the Files tab, use the Drive List and the Directory List to navigate to the
directory that contains the file you want to open.
2 Double-click the file in the file list or right-click the file and choose Edit from the
menu.
Note
Read-only files are marked with a red dot in the file list. You can right-click a file and
choose Properties from the menu to set read and write access. This is not
recommended, however, if you are using a source control application to manage read
and write privileges.
44.
Open all the documents that were open when the program last closed
Open the project that was open when the program last closed
Open a blank document
Open the folder that was last active in the Files tab
Open the folder that was last selected in the File > Open dialog box
Specify a default folder to open at startup
Chapter 4 Managing Files
"About