MACROMEDIA COLDFUSION STUDIO 5-USING COLDFUSION 5 STUDIO Use Manual page 35

Working with Files on Remote Servers
To enable SSL for an FTP connection:
1 Open the Properties dialog box and select the Secure (SSL) option.
2 Click the Configure SSL button and make the appropriate certificate entries.
Click the Help button for information on these settings.
3 Click OK.
This table summarizes the error messages you could receive:
Error message
Unable to connect to the FTP
server.Success
Remote Server Operation Failure:
Winsock Error: Connection aborted.
Secure Connection Error - you have
requested a secure connection to the
server but either the server does not
support SSL or WS_FTP could not
negotiate a secure connection. This
connection is NOT secure. Do you wish
to continue?
To revert to the installed certificate and key:
1 Select Options > Settings > File Settings > FTP & RDS > Reset FTP SSL Certificate
to Default.
2 Click Apply.
Note
For this release,
FTP servers do not get created and saved correctly.
Managing ColdFusion security for RDS
The ColdFusion installation configures basic security for the
requires a password for the ColdFusion Administrator and for ColdFusion Studio.
To change the default security settings:
1 Open ColdFusion Administrator.
2 Select Basic Security from the server link list.
3 Change password security settings as needed.
4 Click the Apply button at the bottom of the page.
Unicode and Unicode Big Endian files that are saved on SSL-enabled
Cause
SSL has not been enabled in the Configure
FTP Server dialog box, and you attempt to
connect to a server requiring SSL.
An SSL-enabled connection is selected at
startup but SSL is disabled on the server.
server
17
and by default