Installing The Maestro Software Package - GRASS VALLEY MAESTRO 1.5 - RELEASE NOTES Release Note

Installing the Maestro Software Package

Maestro — Release Notes
Note It is recommended that all default values be used during the installation.
1. Make a copy of the current configuration set:
a. Launch the Maestro Configuration Editor by going to "Start > All
Programs > Thomson > Maestro Configuration Editor."
b. Use "File > Open" to open the current configuration set.
c. Use "File > Save As" to create a copy of the set.
As a suggestion, add "v14" to the name.
d. Use "File > Save As" again to create another copy of the set.
As a suggestion, add "v15" to the name.
e. Close all Maestro applications.
2. The previous version of Maestro software must be uninstalled before a
new version can be installed. The software can be manually removed
by following the steps below. It can also be automatically removed by
initiating the new software installation procedure in
CAUTION If you are uninstalling v1.3 or v1.4 software, you must use the Administrator
account (login). If you are uninstalling v1.2 or prior software, you must use
the account (login) used when that software was installed.
a. Using the Windows Control Panel, select Add or Remove
Programs.
b. Remove the Maestro Software Package.
This will not remove user data.
c. Close the Windows Control Panel.
3. Insert the new Maestro software CD.
As shown in Figure
is started manually, previously installed Maestro software is automati-
cally detected. The operator is prompted to confirm uninstallation of
this software before proceeding with the installation of the new soft-
ware.
23, when the installation auto runs from the CD, or
Software Upgrade Procedure
Step 3.
41