Related Manuals for Hay 7D
Summarization of Contents
Table Wall Connector Installation
Step 1: Insert Wall Connectors
Begin by inserting wall connectors into the frame profile facing the wall.
Step 2: Mark Placement
Mark wall connector placement using height measurements, ensuring level holes.
Step 3: Mount Table
Mount the table from the top, aligning connectors parallel to wall connectors.
Front Shelf Connector Installation
Step 1: Mount Shelf Connectors
Attach shelf connectors to the groove on the bottom of the shelf.
Step 2: Connect Table
Connect the table by angling the shelf connector into the bottom table frame groove.
Step 3: Secure Connector
Secure the connector from below using screws.
End Shelf Connector Installation
Step 1: Unscrew and Mount
Unscrew underside set screws and mount the end shelf connector with screws.
Step 2: Lock Connector
Connect the table, ensuring the connector profile locks into the table frame groove.
Step 3: Secure Final
Finally, secure the end shelf connector from below using screws.
End Tray Connector Installation
Step 1: Lock Connector
Connect the table, ensuring the tray connector profile locks into the table frame groove.
Step 2: Secure Final
Secure the end tray connector from below using screws.
Cable Tray Installation
Step 1: Mount Tray
Mount the tray from the bottom by angling and sliding the top profile into the table's support bar groove.
Step 2: Mount STEP Module
Mount connectors and lock the STEP module into place with screws.
Cable Clip Installation
Step 1: Mount Cable Clips
Mount cable clips from below by clicking them into the groove on the table frame or support bar.
Cable Guide Installation
Step 1: Mount Cable Guide
Press the cable guide into the groove on the inside of the table leg, starting from the bottom.
Plug Socket Installation
Step 1: Pull Cables and Connect
Pull power cables through holes and connect them to the sockets.
Step 2: Fasten Sockets
Fasten the plug sockets from the bottom using screws.
Step 3: Place Covers
Place the covers over the installed plug sockets.
Need help?
Do you have a question about the 7D and is the answer not in the manual?
Questions and answers