Setbonding [--Mode <Alb | 802.3Ad>, --Mtu <Number>] - Dell DR4000 Reference Manual

administrator@mydr4000 > network --setdns --suffix
storage.local --primary 10.25.20.21 --secondary 10.25.20.25
If no options are specified, the following prompts are shown:
administrator@mydr4000 > network --setdns
--suffix missing: suffix for the DNS entry
--primary missing: primary DNS server
If options are specified, but no values provided, the following prompts are
shown:
administrator@mydr4000 > network --setdns --suffix
--primary
--suffix requires a value : --suffix <dns suffix> suffix for
the DNS entry
--primary requires a value : --primary <ip address> primary
DNS server
--setbonding [--mode <ALB | 802.3ad>, --mtu <number>]
To configure or update the bonding mode or to set the MTU number to use
for a DR4000 system, enter the example commands string at the system
prompt:
administrator@mydr4000 > network --setbonding --mode ALB
--mtu 1750
Bond device operation successful. Please run 'network --
restart' for the changes to take affect.
NOTE:
backup servers are on a remote subnet. This is because ALB uses the address
resolution protocol (ARP) and ARP updates are subnet-specific. Because of
this, ARP broadcasts and updates are not sent across the router. Instead, all
traffic is sent to the first interface in the bond. To resolve this ARP-specific
issue, make sure that the data source systems reside on the same subnet as
the DR4000 system.
ALB load balancing does not balance the load properly when the
Managing the DR4000 System
27