--filesystem [--repair_now]
To repair any filesystem issues in a DR4000 system based on the repair report
findings, enter the following command string at the system prompt:
administrator@mydr4000 > maintenance --filesystem
--repair_now
Successfully started cleaner.
--filesystem [--skip_repair]
To ignore filesystem inconsistencies discovered during the scan process, and
to skip any repairs to the filesystem in a DR4000 system, enter the following
command string at the system prompt:
administrator@mydr4000 > maintenance --filesystem
--skip_repair
--filesystem [--reclaim_space]
To reclaim disk space formerly occupied by data in the recycle bin in a
DR4000 system, enter the following command string at the system prompt:
administrator@mydr4000 > maintenance --filesystem
--reclaim_space
Successfully started cleaner.
--filesystem [--stop_reclaim_space]
If a need exists to stop the disk space reclaim process in a DR4000 system,
enter the following command string at the system prompt:
administrator@mydr4000 > maintenance --filesystem
--stop_reclaim_space
Successfully stopped cleaner.
--filesystem [--start_scan]
To start the filesystem scan process to verify the data contained in a DR4000
system, enter the following command string at the system prompt:
NOTE:
Be aware that using this command places the filesystem into a read-only
mode and pauses all active replications. When the DR4000 system enters
Maintenance mode, an alert is sent that indicates this operational change.
72
Maintaining the DR4000 System