Installing A Hard Disk Drive - IBM 419452u - Servers System X3250 M2 Xeon 3.0ghz Installation Manual

To install a DIMM, complete the following steps:
1. Read the safety information that begins on page v and "Installation guidelines"
2. Turn off the server and peripheral devices, and disconnect the power cord and
3. Open the retaining clip on each end of the DIMM connector.
4. Touch the static-protective package that contains the DIMM to any unpainted
5. Turn the DIMM so that the keys align correctly with the slot.
6. Insert the DIMM into the connector by aligning the edges of the DIMM with the
If you have other devices to install, do so now. Otherwise, go to "Completing the
installation" on page 24.

Installing a hard disk drive

Locate the documentation that comes with the hard disk drive and follow those
instructions in addition to the instructions in this chapter.
Note: The ID for an installed hard disk drive is on the front of the server, next to
the bay that contains the drive.
on page 11.
all external cables. Remove the cover.
Attention: To avoid breaking the retaining clips or damaging the DIMM
connectors, open, and close the clips gently.
metal surface on the outside of the server. Then, remove the DIMM from the
package.
slots at each end of the DIMM connector. Firmly press the DIMM straight down
into the connector by applying pressure on both ends of the DIMM
simultaneously. The retaining clips snap into the locked position when the DIMM
is firmly seated in the connector. If there is a gap between the DIMM and the
retaining clips, the DIMM has not been correctly inserted; open the retaining
clips, remove the DIMM, and then reinsert it.
Chapter 2. Installing optional devices
15