Monitor Connection - Sanyo VCC-ZM600 Installation Manual

Connection with a communication device for remote operation
✱3 UTP (Unshield Twist Pair) cable: LAN Category 5 or higher
✱3
Digital Video
Recorder etc.
Power Supply Connection
b With AC 24 V
GND GND
~ ~
~ ~
For the connections, use cables thicker
than 18 AWG.
b With DC 12 V
Check that +/- polarity is correct.
– –
+ +
For the connections, use cables thicker
than 18 AWG.
Color or Black-and-White Setting
The alarm input terminals can
also be used as terminals for
switching between color and
black/white video modes using
an external switch.
NVT
Receiver
Open: Color
Close: Black/White
SYNC
INT
CAMERA 1 y
LENS y
SET
ALARM SET y
PRIVACY MASK SET y
PASSWORD SET y
LANGUAGE SET y
OPTION SET y Make sure that
COLOR is selected.
6
SYSTEM DEVICE
(ex. Monitor)
To output video signal,
select the connection of a
coaxial cable or a UTP
cable.

Monitor Connection

• Using different cables from those
specified here may attenuate the
video and/or sync signals and
interfere with correct transmission.
• RG-59U coaxial cables can be
used when distance between
devices is short, but not in duct or
aerial routing.
Cable type
RG-59U (3C-2V)
RG-6U (5C-2V)
RG-11U (7C-2V)
(COM)
(ALARM IN 1 or 2)
GAMMA 0.45
MOTION OFF
POSITION OFF
DAY/NIGHT COLOR y
PRESET OFF
MENU BACK
1: ALARM IN 1 terminal
2: ALARM IN 2 terminal
Controller
Length
250 m (273 yds) max.
500 m (547 yds) max.
600 m (656 yds) max.
D/N SETTING-COLOR
EXT ALARM 1