Connecting To An Existing Network - Sony Ipela NSR-S10 Quick Start Manual

Playing a recording from a specified date and
time
You can specify the date time of the recorded image that
you want to play at the bottom of the screen.
2
1 If you want to play an image that was recorded
today, click the corresponding time button.
2 If you want to play an image from a specified date
and time, and click
the date on the calendar that appears, and specify
camera IDs and time on the time table.
Time periods for which recorded images exist are
displayed in .
Click a time period to select it, and the selected
time period will become
Camera IDs
3 Click [OK].
The images are played back.
This concludes basic verification.
To use other NSR features and configure
advanced settings
For details on using preset functions to control the
camera, enabling alarm recording, and using other NSR
features, refer to the User's Guide (PDF).
12

Connecting to an Existing Network

1
(Date Selection). Specify
.
Time periods
Connecting to an
Existing Network
If the IP addresses of the cameras are set to factory
default conditions when you connect the NSR to the
network, the NSR will automatically change the camera
IP addresses and create a network that consists only of
the NSR and the cameras.
Be sure to configure the following settings when
connecting to an existing network and using the NSR.
For details on each operation, refer to the User's Guide
(PDF).
1
Turn on the NSR, and log onto the NSR.
2
Configure the IP address for the NSR.
Click (Network Setting) in the "Setup" screen,
and configure the IP address for the NSR in the
"Network Setting" screen that appears.
1 Click [Setting] for [LAN1 IP] or [LAN2 IP].
2 Configure the IP address, subnet mask, and
default gateway for the NSR, and the IP address
for the DNS.
3
Connect the NSR to the network.
4
Restart the NSR.