Chapter 2 Preparations; Starting The Unit; Connecting The Unit To A Power Source - Sony PMW-EX30 Operating Instructions Manual

Preparations

Starting the Unit

When you use this unit for the first time
after purchasing, the initial settings are
required (see page 26).
Connecting the unit to a
power source
Use the supplied MPA-AC1 AC Adaptor to
connect the unit an AC power source.
DC power cord
(supplied)
MPA-AC1 AC Adaptor (supplied)
AC power cord
(supplied)
When this unit is supplied with power, the
power indicator on the front panel lights in
red. (The unit enters the standby state.)
Starting the unit
To start this unit, press the power button
with the power indicator lit in red (when the
unit is in the standby state).
26 Starting the Unit
DC IN
To an AC
power source
Chapter
Power indicator
Power button
VIDEO INPUT switch
LCD display
DISPLAY
1
REC LEVEL
CH-1
VIDEO INPUT TC/UB
iLINK
HD SDI
SG
CH-2
AUDIO INPUT STATUS
ANALOG
HD SDI
CH-1/2
HD SDI
CH-3/4
F REV PREV NEXT F FWD PLAY/PAUSE
PHONES PHONE LEVEL
m . > M
u
TOP END
Note
No signal is output from the
COMPONENT, COMPOSITE, S-VIDEO,
HDMI, HD/SD SDI OUTPUT, and HDV/
DV connectors until the start-up completes.
When the start-up of the unit is completed,
the power indicator lights in green.
When the initial setting display
appears on the LCD display
The initial setting display appears on the
LCD display in the following situations.
• When turning on the unit for the first time
• When turning on the unit after the clock
setting is cleared because of exhaustion
of the backup battery while no operation
power was being supplied (no AC power
connection)
For details on the initial settings, see "Setting the
Clock" (page 27).
2
MENU SET
ACCESS
A B
THUMBNAIL CANCEL
STOP REC
SLOT
x z
SELECT