Table of Contents
Advertisement
[Check New Password]
Reenter the new password.
The new password is saved.
Network Settings
Configure initial settings for the network and server.
1
Select [Network Settings] in the [System Admin
Settings] screen, and press the ENTER button.
The [Network Settings] screen appears.
2
Select a tab, and press the ENTER button.
3
Configure the settings in each tab as necessary.
For details on each tab, see the following.
[Network] Tab (page 77)
[IP Address] Tab (page 77)
[DNS Server] Tab (page 78)
[File Server] Tab (page 78)
[Shared] Tab (page 78)
[NTP] Tab (page 78)
[Streaming] Tab (page 78)
4
When you finish configuration, select [Apply] and
press the ENTER button.
The configurations are saved, and the [System Admin
Settings] screen appears again.
[Network] Tab
Configure these settings when using a network.
[Network]
Select whether to use a network.
The default setting is [Not Used].
If you selected [Use], configure the settings in each tab as
necessary.
[IP Address] Tab
[Auto IP address]
Select [Use] to use the DHCP to obtain an IP address
automatically, or select [Not Used] to assign a static IP
address manually.
If you selected [Use], the IP address, subnet mask, and
default gateway will be displayed as read-only.
If you selected [Not Used], be sure to configure the [IP
Address], [Subnet Mask], and [Default Gateway]
settings.
77
Advertisement
Table of Contents
