Operations (Step 4 Setting with V.Networks Controller)
Starting Up V.Networks Controller
With the installed Controller, camera images can be monitored. The settings for
recording, replay and frame rate etc. can also be performed.
1.
Select [Start], [Programs], [V.NETWORKS] and then
[V.Networks Controller].
Note
• If a password has been set, enter the correct password.
• This [Controller] can be connected to VN-C1, VN-C2, VN-C3, VN-C30 (only for JPEG), VN-
A1 and VN-C10.
[vn-c10u Controller] to start up
In the pull down menu, select the camera
to connect.
Caution
After the power for VN-C10 is turned
on, there will be about 20 seconds until
VN-C10 becomes ready to be con-
nected with the PC. This is not a de-
fect.
Live images from the camera are dis-
played.
25