Table of Contents
Advertisement
Installation
Installation
Notes
• The installation should be done by qualified service personnel or sytem installers.
• If the ceiling material is not strong enough to hold the installation screws, the camera
may fall off. Reinforce the ceiling as needed.
1) Separate the dome cover by rotating anti-clockwise.
2) Separate the shield case by pulling from the camera body.
* To install the dome cover on the camera
body, turn the latches in locking direction as
shown in the Figure-1.
Latch
Locking direction
[Figure-1]
Unlocking direction
(Anti-clockwise)
12
COLOR DOME CAMERA
Main Body
(Camera)
Shield Case
Locking direction
(Clockwise)
Dome cover
SUD-3080
When installing on a adapter plate
An arrow for installing directions
Adapter plate
M4 tapping
screw (provided)
CAMERA
Locking
direction
Unlocking
direction
Dome cover
Notes
• Please locate an arrow on bracket for installing direction that you wish to observe Area
and then fix it with the M4 tapping screws.
COLOR DOME CAMERA
1) Place the bracket provided on the
installation surface and fix it with the M4
tapping screws (provided).
2) When placing the camera body on the plate,
insert the plate pin into the mounting hole
on the body as shown in Figure-2 and fix it
by turning clockwise.
3) When placing the camera body on the plate,
make sure the camera cables pass through
their respective designated holes.(When
placing the cable through its side, thread it
through the hole at the bottom.)
4) After installation and adjustment of the
camera are complete, secure the dome
cover by turning it clockwise.
Plate pin
Locking direction
Unlocking direction
[Figure-2]
13
SUD-3080
Advertisement
Table of Contents
