Table of Contents
Advertisement
Operating Your Camera
RETURN : Select this to save the MASK AREA menu settings and return to the
INTELLIGENCE menu.
SENSITIVITY : Set the sensitivity of the motion detection. When adjusting the
sensitivity, note that the lower the level means the higher sensitivity.
DETECT SIZE : Selects an object size to detect on the screen. When adjusting the detection
size, note that the higher the level means the bigger detection size.
RETURN : Select this to save the INTELLIGENCE menu settings and return to the
SPECIAL menu.
PRIVACY : Mask an area you want to hide on the screen.
PRIVACY AREA SETUP
1.AREA
2.MODE
3.MASK COLOR
4.TRANSPARENCY
5.SEL POS
6.XPOS
7.YPOS
8.RETURN
1) When the SPECIAL menu screen is displayed, press the Function Setup switch so that
the arrow indicates 'PRIVACY'.
2) Set up the mode using the Function Setup switch.
AREA : You can select up to 12 PRIVACY areas.
MODE : Determines whether to use the area selected in the AREA.
MASK COLOR : Determine area color. You can select Green, Red, Blue, Black, White, Gray.
TRANSPARENCY : Adds or removes transparency from the masking area.
SEL POS/ XPOS/ YPOS : Adjust the size and position of the selected area.
RETURN : Select this to save the PRIVACY menu settings and return to the SPECIAL menu.
DIS (Digital Image Stabilizer) : This function mitigates any picture movement due to external
factors such as wind.
Notes
• As the DIS function uses the digital zoom, the camera's resolution will decrease.
• DIS doesn't operate when background illumination is too low.
• DIS doesn't operate when object pattern is monotonic as like sky or white wall.
COLOR DOME CAMERA
AREA1
OFF
GREEN
OFF
L_TOP
10
10
38
SUD-3080
COMM ADJ (Communication Adjustment) :
This function sets up the camera communication status when controlling the camera
through an external control device.
1) When the SPECIAL menu screen is displayed, press the Function Setup switch so that
the arrow indicates 'COMM ADJ'.
2) Set up the mode using the Function Setup switch.
COMM SETUP
1.CAM ID
2.BAUD RATE
3.UART MODE
8-N-1
4.RET PKT
ENABLE
5.DISP ID
6.PROTOCOL
SAMSUNG-T
7.RETURN
CAM ID : Determines the camera's identification number (between 0 and 255).
BAUD RATE : You can select 2400/4800/9600/19200/38400/57600 bps.
UART MODE : You can select NONE, EVEN or ODD for the parity bits.
RET PKT : Determines whether to send a command back to the controller device when a
communication control command is sent to the camera.
DISP ID : Display camera title on top left corner of the screen.
PROTOCOL : Select the communication PROTOCOL. (SAMSUNG-T, SAMSUNG-E , PELCO-D,
PELCO-P, BOSCH, HONEYWELL, VICON and PANASONIC)
RETURN : Select this to save the PRIVACY menu settings and return to the SPECIAL menu.
* Initial value of communication adjustment
Item
Camera ID
BAUD RATE UART MODE
Initial value
1
9600
8-NONE-1
COLOR DOME CAMERA
1
9600
OFF
PET PKT
ENABLE
39
SUD-3080
Advertisement
Table of Contents
