Adjusting The Camera Position; Adjusting The Lens - JVC TK-T2101RU Instructions Manual

Fixed ir dome camera

Hide thumbs Also See for TK-T2101RU:

Table of Contents

INSTALLATION

2.5 Adjusting the Camera Position

The dome camera has three axes for positioning the camera. While monitoring the

picture on the monitor, adjust the camera position as follows:

Horizontal Adjustment Rotate 3D assembly in the base. Do not turn assembly

more than 360° as this may cause the internal cables to twist and disconnect or

break.

Before making horizontal adjustment, please adjust vertical adjustment to 90

degree (vertical) first.

Vertical Adjustment After loosening the screw on the bracket, position the camera

as desired, then tighten the screw back to the bracket.

Horizontal Rotation For wall mount and tilted ceilings, rotate the lens base

(maximum 360°) until you are satisfied with the field of view.

1. Loosen the focus lever counter-clockwise a little, then adjust the focus for

optimum picture sharpness.

2. Loosen the zoom lever counter-clockwise a little, then rotate the zoom lever and

determine the image view.

3. Re-tighten the zoom lever and focus lever after adjustment.

Note: It is important that you lock the

adjustments. This will avoid the positions moving (for example, from temperature

changes or vibrations).

Figure 2-4 Camera adjustment

zoom

and focus levers after making

1. Rotate 3D assembly in base for

horizontal adjustment

2. Tilt adjustment bracket and screw

for vertical adjustment

3. Axis ring for horizontal rotation

for wall mount and tilted ceilings

Table of Contents

Tk-t2101re