Table of Contents
Advertisement
Installation and connection
Mounting the Camera to the Ceiling (Continued)
9.
Power supply
cable
Roll with tape
BNC connector
4 inch square
electrical box
Mounting
M o u n t -
holes
ing
10.
holes
Shooting
direction
11.
Screws
Connection for Adjustment of the Camera
Temporarily used for making various adjustments
while the camera remains in the installed location.
FOCUS ADJ.
OFF
ON
OFF
ON-AGC
OFF
ON-BLC
AUTO
MANU
LL
INT
PHASE
WHT.BAL.
R
B
SPOT
RESET
CORRECTION
FOR
L
H
SERVICE
IRIS
LEVEL
MONITOR
IRIS
LEVEL Volume
* The power to the camera body must be ON when adjustments are performed.
E-12
9.
Roll cables with insulation tape.
As shown in the diagram to the left, roll
the entire connecting section of the
power supply cable and BNC connec-
tor with insulation tape and insert them
in the electrical box.
MEMO
Rolling cables with insulation tape not only
increases the work efficiency later on, but
reduces the entry of noise, etc.
10 .
Adjust the unit in the direction to shoot.
11 .
When using an electrical box, use the
2 mounting holes to fix the box to the
unit.
CAUTION:
• Do not hold the lens part when mounting
the unit to the ceiling or wall.
• When directly mounting the unit to the
ceiling or wall, fix the unit using all 4
mounting holes.
• Use M4 screws or bolts for attaching the
ceiling mount.
• If wood screws are used, use screws
with a diameter of 4.1 mm.
Setting switch
Adjustment
button
75Ω termination
Monitor TV
disconnected
Adjusting the Camera Angle
Horizontal
Lock screw
Variable
range 120˚
Tilt lock
screws
80˚
50˚
Vertical rotation
Rotation levers
Zoom ring
Focus ring
Tilt lock screws
Horizontal rotation
(adjustable range: 120°)
1.
Loosen the horizontal LOCK screw.
2.
Holding the both tilt lock screws, rotate
horizontally.
3.
Tighten the horizontal LOCK screw.
Vertical rotation
(adjustable range: +80°, -50°)
1.
Loosen the tilt lock screws.
2.
Holding the rotation levers, rotate
vertically.
3.
Tighten the tilt lock screws.
Image inclination
(adjustable range: ±15°)
Manipulate the rotation levers to adjust the
inclination of the image.
Adjusting the image size
Adjust the size using the zoom ring.
Adjusting the focus
Adjust using the focus ring.
When adjusting the focus, set the FOCUS
ADJ. switch to "ON". After adjustment is
completed, set the FOCUS ADJ. switch to
"OFF".
When required, the surveillance image
should be adjusted, etc.
E-13
Advertisement
Table of Contents
