Adjusting The Camera Position; Adjusting Zoom And Focus; Mounting The Camera - JVC VN-T216 Quick Manual

Adjusting the Camera Position

The dome camera has three axes for positioning the camera. While monitoring the picture on the
monitor, adjus t the camera position as follows:

Adjusting Zoom and Focus

Mounting the Camera

Pan Adjustment (A) For Wall Mount and Tilted Ceilings Rotate the lens base
(maximum360° ) until you are satisfied with the field of view.
Horizontal Rotation (B) Rotate 3D assembly in the base. Do not turn assembly more than
360° as this assembly may cause the internal cables to twist and disconnect or break.
Tilt Adjustment (C) After loosening the thumbnuts, position the camera as desired, then
finger –tighten the thumbnuts to set the position.
Do not turn the lens more than 360° as this may caus e internal cables to disconnect
Caution
or break.
Loosen the zoom lever (D) / locking screw by turning it counter-clockwise.
Rotate the zoom ring to achieve the desired picture.
Loosen the focus lever (E) / locking screw by turning it counter-clockwise.
Rotate the focus ring to adjust the focus.
If re-adjustment is necessary, repeat the steps above.
Retighten the zoom lever (D) / locking screw and the focus lever (E) / locking screw.
Retighten the locking screws to prevent loss of adjustment.
Caution
Place the mounting template (supplied) on the mounting surface and mark the holes.
Drill two holes, and then insert the screw anchors into the holes.
Take off the camera housing.
Connect the Safety Wire (Fall Prevention Wire, not supplied) to the ceiling.
4